Equipment Design

Spare Part and Reverse Engineering Drawings – Calculations, 3D Model and Fabrication Drawings

SLETEC prepares spare part drawings for worn, broken or obsolete components so they can be made by a local machine shop or foundry instead of waiting for the original manufacturer. We start from the part itself, photos, a scan or an old sketch.

We measure an existing part or use photos and scans to make 3D models and manufacturing drawings, so you can make spare parts locally.

Also searched as: copy a part, drawing from sample.

Fixed-price quote in 24 hoursSmall jobs welcomeAPI · ASME · AISC · Saudi Aramco

Last updated:

Request Engineering Support

Typical response within 24 hours · Confidentiality assured

Send us your data sheet, sketch or old drawing on WhatsApp (+966 55 545 8298) or email (enquiry@sletec.com) for a fixed-price quote, usually within 24 hours.

What we need to start

The best input is the physical part, ideally with its mating parts or at least their key dimensions. A worn part is still useful, but we need to know which surfaces are worn so we can restore the original dimension rather than copy the damage.

If the part cannot be removed, clear photos with a scale reference and a few measured dimensions are often enough for simple components.

  • The part, photos with a scale, or a 3D scan
  • Mating parts or the equipment model and serial number
  • Operating conditions: speed, load, temperature and fluid
  • Material information from the original drawing, a hardness test or PMI
  • Quantity needed and the intended manufacturing method

Reverse engineering drawings: the decisions behind the dimensions

Measuring is the easy part. The engineering is in deciding tolerances and fits, since a measured bore of 50.02 mm could be a 50 H7 fit or a worn 50 mm hole.

We assign fits from the function of the joint, add surface finish where it matters, and apply ASME Y14.5 geometric tolerancing to features that control alignment.

Standards used on replacement part drawings
StandardWhat it governs
ASME Y14.5Geometric dimensioning and tolerancing
ISO 286Limits and fits for holes and shafts
ISO 2768General tolerances where no specific tolerance is given
ISO 1302 / ISO 21920Surface texture indication

Replacement part drawing deliverables

You receive a 3D model, a dimensioned 2D manufacturing drawing with material, heat treatment, finish and tolerances, and DXF files for profile-cut parts. For castings we can prepare a separate as-cast drawing with machining allowance and a machined-part drawing.

Common pitfalls

Copying a worn part, guessing the material, or omitting heat treatment are the usual reasons a locally made spare fails early. Our reverse-to-fabrication project and reverse engineering service show the method in more detail.

How a spare part job runs

After receiving the part or photos, we confirm what can be measured and which details need your input, such as material or heat treatment. We model the part, issue a draft drawing for your workshop to review, and finalise it after comments. For assemblies, each part gets its own drawing number so replacements can be ordered one at a time.

Frequently Asked Questions

Can you design a spare part and reverse engineering drawings for our project?

Yes. We prepare calculations and drawings to ASME Y14.5 and your project specification.

Do you take small jobs?

Yes. Single drawings, one calculation or a check of an existing design are welcome.

Which countries do you serve?

Saudi Arabia, UAE, Qatar, Oman, Kuwait, Bahrain and worldwide.

Send your sketch, photo or PDF today

One drawing or a complete design package — we reply with a fixed-price quote, usually within 24 hours.

Request Engineering Support

Typical response within 24 hours · Confidentiality assured