Pipe Support Design – Calculations, 3D Model and Fabrication Drawings
Our pipe support calculation work takes the loads from pipe stress analysis and confirms that each shoe, guide, anchor, trunnion and spring can carry them without overloading the pipe or the steel it sits on.
We design standard and special pipe supports, shoes, guides, anchors, trunnions and spring hangers, with stress checks and drawings.
Also searched as: pipe support drawing, pipe shoe, pipe clamp.
Last updated:
Request Engineering Support
Typical response within 24 hours · Confidentiality assured
What we deliver
Send us your data sheet, sketch or old drawing on WhatsApp (+966 55 545 8298) or email (enquiry@sletec.com) for a fixed-price quote, usually within 24 hours.
Inputs for special supports
Standard supports are picked from the project catalogue. Special supports are needed when loads, temperature or geometry fall outside it, and those need a calculation.
We work from the stress isometrics and the support load summary, with the load cases clearly identified as sustained, operating, occasional or hydrotest.
- Pipe size, schedule, material, design temperature and insulation thickness
- Support loads and movements from the stress analysis for each load case
- Support type required: shoe, guide, line stop, anchor, trunnion, clamp or spring
- The supporting steel or concrete and its available capacity
- Client standard support drawings, if a catalogue exists
MSS SP-58 supports and related checks
MSS SP-58 now covers the material, design and manufacture of hangers and supports that were previously spread across several MSS documents.
| Code | What it governs |
|---|---|
| MSS SP-58 | Hanger and support types, materials, allowable stresses and spring manufacture |
| ASME B31.3 / B31.1 | Pipe stress limits that the support arrangement must satisfy |
| WRC 107 / WRC 537 | Local stress in the pipe wall at trunnions and welded attachments |
| AISC 360 | Support steel, welds and base plates |
Pipe support drawings and spring selection
Each special support gets a drawing with dimensions, weld sizes, materials and the design load. Spring hangers are selected so that load variation between installed and operating positions stays within the limit set by the stress engineer, and the drawing shows the cold and hot load settings.
Problems found in operating plants
Field walks often find shoes that have slid off the beam, springs bottomed out or still locked with travel stops, guides seized with corrosion and supports that have lifted off as the pipe expands. Each one can shift load to nozzles on pumps or vessels. We record the condition, re-check the stress model and issue revised details. Related work is on our pipe support design service and pipe stress analysis pages.
How a support job runs
We receive the stress isometrics and support list, mark which supports are standard and which need a special design, and issue calculations and drawings for the special ones in batches. That lets the piping contractor start fabrication of finished batches while the rest of the special supports are still in design.
Related engineering topics
piping design services, pipe stress analysis, pipe support design and hydraulic calculations.
Frequently Asked Questions
Can you design a pipe support for our project?
Yes. We prepare calculations and drawings to ASME B31.3, MSS SP-58 and your project specification.
Do you take small jobs?
Yes. Single drawings, one calculation or a check of an existing design are welcome.
Which countries do you serve?
Saudi Arabia, UAE, Qatar, Oman, Kuwait, Bahrain and worldwide.
Related pages
Serving all GCC countries
Send your sketch, photo or PDF today
One drawing or a complete design package — we reply with a fixed-price quote, usually within 24 hours.
Request Engineering Support
Typical response within 24 hours · Confidentiality assured