Separator Design – Calculations, 3D Model and Fabrication Drawings
SLETEC provides separator design for production, test and fuel gas service, combining process sizing of the vessel and internals with the mechanical calculation and drawings needed for fabrication. The same approach applies to knock-out drums and scrubbers.
We prepare mechanical design, internals arrangement, nozzle loads, supports and fabrication drawings for two-phase and three-phase separators, KO drums and scrubbers.
Also searched as: oil gas separator, 3 phase separator.
Last updated:
Request Engineering Support
Typical response within 24 hours · Confidentiality assured
What we deliver
Send us your data sheet, sketch or old drawing on WhatsApp (+966 55 545 8298) or email (enquiry@sletec.com) for a fixed-price quote, usually within 24 hours.
Two-phase separator or three-phase separator
A two-phase vessel splits gas from liquid. A three-phase vessel also separates oil from water, which needs enough liquid residence time for droplets to settle and a weir or bucket arrangement to draw the two liquids off separately.
Horizontal vessels suit high liquid loads and three-phase duty, while vertical vessels suit high gas-to-liquid ratios and small plot space.
Process inputs we work from
Sizing depends on flow rates and fluid properties, so the heat and mass balance comes first.
- Gas, oil and water flow rates at normal and design conditions
- Densities, viscosities and operating pressure and temperature
- Required liquid residence time and surge volume
- Slug size if the vessel receives flow from a multiphase line
- Allowable liquid carry-over in the gas outlet and oil-in-water limits
KO drum design and the codes behind it
Gas capacity is set with the Souders-Brown approach, using a K-value that depends on the mist eliminator chosen. For flare knock-out drums the sizing follows the droplet settling method in API 521.
| Code | What it governs |
|---|---|
| API 12J | Oil and gas separators: sizing guidance, internals and nozzle considerations |
| API 521 | Flare knock-out drum sizing and liquid hold-up |
| ASME VIII Div. 1 | Shell, heads, nozzles, supports and test pressure |
| Client specifications | SAES / SAMSS, SABIC or ADNOC requirements and the project specification |
Internals and problems on existing vessels
Internals include inlet devices such as half-pipes or vane inlets, mesh pads or vane packs, vortex breakers, weirs and sand jetting where needed. On existing separators we often find liquid carry-over after a production increase, damaged mesh pads, and level bridles in the wrong place for the new interface level. Our references include detailed engineering of biphasic separators and replacement fuel-separator engineering; see our static equipment design project.
How a separator job runs
Process sizing comes first and is issued as a sizing note with vessel diameter, length, nozzle sizes and internals arrangement. After you approve it, the mechanical calculation, GA, internals drawings and fabrication drawings are prepared. Nozzle loads from piping are checked once the stress engineer issues them, and changes are tracked through numbered revisions.
Related engineering topics
pressure vessel design, static equipment design, nozzle local stress FEA and pressure vessel FEA ASME VIII Div 2.
Frequently Asked Questions
Can you design a separator for our project?
Yes. We prepare calculations and drawings to ASME VIII, API 12J and your project specification.
Do you take small jobs?
Yes. Single drawings, one calculation or a check of an existing design are welcome.
Which countries do you serve?
Saudi Arabia, UAE, Qatar, Oman, Kuwait, Bahrain and worldwide.
Related pages
Serving all GCC countries
Send your sketch, photo or PDF today
One drawing or a complete design package — we reply with a fixed-price quote, usually within 24 hours.
Request Engineering Support
Typical response within 24 hours · Confidentiality assured