Equipment Design

Pipe Rack Design – Calculations, 3D Model and Fabrication Drawings

A pipe rack design calculation from SLETEC turns the piping and cable tray loads into a steel frame that is checked for strength, drift and connection capacity. The output is ready for detailing and fabrication.

We design steel pipe racks and pipe bridges for new and existing plants, including load calculations, connections, base plates and fabrication drawings.

Also searched as: pipe bridge, pipe support structure.

Fixed-price quote in 24 hoursSmall jobs welcomeAPI · ASME · AISC · Saudi Aramco

Last updated:

Request Engineering Support

Typical response within 24 hours · Confidentiality assured

Send us your data sheet, sketch or old drawing on WhatsApp (+966 55 545 8298) or email (enquiry@sletec.com) for a fixed-price quote, usually within 24 hours.

Design inputs for pipe rack steel design

Pipe loads come from the piping layout and stress analysis, and they are rarely final when the rack design starts. We agree a load basis early, using line-by-line loads where they exist and a uniform allowance elsewhere, plus a reserve for future lines.

Anchor and guide forces from the stress engineer are applied as point loads, as they often govern the longitudinal bracing.

  • Pipe sizes, contents and insulation on each tier, empty, operating and hydrotest
  • Anchor, guide and friction loads from pipe stress analysis
  • Cable tray and instrument tray loads, and any air cooler or platform on top
  • Bent spacing, tier elevations and road crossing clearances
  • Site wind, seismic and temperature range

Governing codes and load combinations

Most racks are moment frames across the rack and braced frames along it. The codes below set the load combinations and member checks.

Codes used for pipe racks
CodeWhat it governs
ASCE 7Wind, seismic and load combinations
AISC 360Member, base plate and connection design
PIP STC01015Structural design criteria widely used for process plant racks
ACI 318Pedestals, footings and anchor bolts
Client specificationsSAES or company standards for rack loading and future space

Pipe rack drawings we issue

Deliverables include the analysis model and report, key plans and elevations, bent and bracing elevations, connection details, base plate and anchor bolt layouts, and fabrication drawings with a bill of materials. Foundation loads are tabulated for each column so the civil team can design footings without waiting for the full model.

Problems we see on existing racks

Brownfield racks are often fully loaded with no record of the original design load. New lines get added without checking, and corrosion at the base plates and under pipe shoes reduces capacity further. We survey, back-calculate the existing capacity and propose strengthening or a new tier. See our pipe rack structural design service and structural platform FEA project.

How a rack job runs

We agree the load basis and structural system, build the analysis model and issue the report with a foundation load table. Once the bent layout is frozen, connection design and fabrication drawings follow. On a brownfield extension we start with a survey of the existing bents so the new steel ties in at the right elevations and grid lines.

Frequently Asked Questions

Can you design a pipe rack for our project?

Yes. We prepare calculations and drawings to AISC 360, ASCE 7 and your project specification.

Do you take small jobs?

Yes. Single drawings, one calculation or a check of an existing design are welcome.

Which countries do you serve?

Saudi Arabia, UAE, Qatar, Oman, Kuwait, Bahrain and worldwide.

Send your sketch, photo or PDF today

One drawing or a complete design package — we reply with a fixed-price quote, usually within 24 hours.

Request Engineering Support

Typical response within 24 hours · Confidentiality assured