Lifting Beam and Spreader Bar Design – Calculations, 3D Model and Fabrication Drawings
SLETEC offers lifting beam design for beams, spreader bars and lifting frames used under cranes and hoists, with calculations, drawings and the marking details needed before the device goes for proof load testing.
We design lifting beams, spreader bars, lifting frames, padeyes and lugs with calculations and drawings ready for load testing.
Also searched as: lifting frame, lifting tool.
Last updated:
Request Engineering Support
Typical response within 24 hours · Confidentiality assured
What we deliver
Send us your data sheet, sketch or old drawing on WhatsApp (+966 55 545 8298) or email (enquiry@sletec.com) for a fixed-price quote, usually within 24 hours.
Lifting beam or spreader bar design
The two look similar but carry load differently. A lifting beam hangs from one or two crane hooks and carries the load in bending, so beam depth and lateral-torsional buckling govern. A spreader bar sits between angled slings and is mainly in compression, so column buckling and the end fittings govern.
We confirm which arrangement suits your headroom and crane before sizing either one.
Inputs for a below-the-hook lifting device
Below-the-hook devices are designed for a defined duty, so the inputs include how often the device is used, not only how much it lifts.
- Rated load, the heaviest item and its centre of gravity
- Pick-up point spacing on the load and available headroom under the hook
- Number of crane hooks, and whether the load must be adjustable for different centres of gravity
- Expected number of lifts over the service life
- Operating environment: indoor workshop, outdoor site, offshore or low temperature
ASME BTH-1 design and related standards
ASME BTH-1 sets the design factor through the Design Category and sets fatigue requirements through the Service Class, which is based on the number of load cycles.
| Standard | What it governs |
|---|---|
| ASME BTH-1 | Design category, service class, member, connection, pin and weld checks |
| ASME B30.20 | Marking, rated load test, inspection and operation of below-the-hook devices |
| AISC 360 | Steel member checks where the client specification calls for it alongside BTH-1 |
| EN 13155 | Non-fixed load lifting attachments on projects following European standards |
Deliverables and testing
We issue a calculation report, GA and detail drawings, weld and NDT requirements, and a marking plate detail showing rated load and the device's own weight. The drawing notes state the proof load test required by ASME B30.20 so the workshop and third-party inspector work to the same figure.
Problems with existing devices
Common issues are devices with no rated load marking, unknown steel grade, lugs added later without calculation, or a beam reused for a heavier load than it was built for. We can back-calculate the capacity and prepare a re-rating note or modification drawings. Related scope is on our lifting and rigging calculations page.
Related engineering topics
lifting and rigging calculations, lifting lug calculation and skid design.
Frequently Asked Questions
Can you design a lifting beam and spreader bar for our project?
Yes. We prepare calculations and drawings to ASME BTH-1, ASME B30.20 and your project specification.
Do you take small jobs?
Yes. Single drawings, one calculation or a check of an existing design are welcome.
Which countries do you serve?
Saudi Arabia, UAE, Qatar, Oman, Kuwait, Bahrain and worldwide.
Related pages
Serving all GCC countries
Send your sketch, photo or PDF today
One drawing or a complete design package — we reply with a fixed-price quote, usually within 24 hours.
Request Engineering Support
Typical response within 24 hours · Confidentiality assured