Skid Base Frame Design – Calculations, 3D Model and Fabrication Drawings
Our skid base frame design keeps pumps, compressors and packaged equipment aligned in service and safe during lifting, transport and installation. It covers the main beams, cross members, deck plate, drip pan, lifting points and anchor locations.
We design skid frames, piping, lifting points and transport checks for pump, metering, chemical injection, filtration and compressor skids.
Also searched as: pump skid, metering skid, package unit.
Last updated:
Request Engineering Support
Typical response within 24 hours · Confidentiality assured
What we deliver
Send us your data sheet, sketch or old drawing on WhatsApp (+966 55 545 8298) or email (enquiry@sletec.com) for a fixed-price quote, usually within 24 hours.
Inputs for a skid frame calculation
We need the equipment list with weights, centres of gravity and footprints, plus the piping and valve layout on the skid. For rotating machines the vendor's baseplate requirements and running speed are also needed, because a flexible frame can sit close to a resonance.
The transport route matters too. A skid shipped by sea sees much higher accelerations than one trucked a short distance.
- Equipment weights, centres of gravity and vendor anchor patterns
- Piping, valve and instrument weights, and nozzle loads from connecting piping
- Lifting method: four-point lift, spreader bar or forklift pockets
- Transport mode and the acceleration criteria from the client or marine warranty surveyor
- Foundation type at site: concrete plinth, steel structure or direct grouting
Load cases and codes
A skid frame sees its worst loads before it ever runs. We check each stage of its life as a separate case.
| Load case | Governing code or basis |
|---|---|
| Lifting with dynamic factor | ASME BTH-1 for lugs; AISC 360 for frame members |
| Transport and sea fastening | Client or marine warranty criteria; DNV-ST-N001 for marine operations |
| Operating with nozzle loads | AISC 360; API 610 baseplate stiffness for pump skids |
| Vibration | Frequency separation from running speed, checked by modal analysis where needed |
| Piping on skid | ASME B31.3 |
Skid lifting design
Lifting lugs are placed so the skid hangs level, with the centre of gravity inside the lifting points and slings clear of equipment. Where headroom or sling angles are tight, we design a spreader frame so the skid sees vertical loads only.
Problems on existing skids
Typical findings are misalignment after a frame twisted during lifting, cracked welds at lug locations, and pump vibration caused by a frame natural frequency near running speed. Our fire water pump skid vibration project shows how we diagnose this, and our skid design and fabrication drawings service covers new skids.
How a skid job runs
We agree the equipment layout and lifting method, build the frame model with all equipment and piping weights, and run the lifting, transport and operating cases. The skid GA, frame fabrication drawings, lifting lug details and a weight and centre of gravity report are then issued together, so the rigging contractor and the workshop work from the same figures.
Related engineering topics
mechanical design services, skid design, machine design services and machine design.
Frequently Asked Questions
Can you design a skid for our project?
Yes. We prepare calculations and drawings to AISC 360, ASME B31.3 and your project specification.
Do you take small jobs?
Yes. Single drawings, one calculation or a check of an existing design are welcome.
Which countries do you serve?
Saudi Arabia, UAE, Qatar, Oman, Kuwait, Bahrain and worldwide.
Related pages
Serving all GCC countries
Send your sketch, photo or PDF today
One drawing or a complete design package — we reply with a fixed-price quote, usually within 24 hours.
Request Engineering Support
Typical response within 24 hours · Confidentiality assured